Sanitary Bulk Material Handling Equipment: Materials of Construction In Process-specific Applications
The sanitary-specific construction of this bulk material tote dumper exemplifies OCC design.
In an earlier post, some of the risks of integrating process-inappropriate equipment into sanitary bulk material handling applications were presented. In that post it was noted that many sanitary processing operations settle for force-fit, general industrial equipment rather than process-specific, sanitary bulk material handling equipment. "Clearly, there are degrees, or relative levels to sanitary compliance," says Tom Krueger, CMC, president of Summit Laboratory. "It is critical to recognize how the sanitary-specific construction of process-appropriate, sanitary bulk material handling equipment can translate to improved product safety, and a greater optimal compliance contribution". (OCC)
Materials of construction is referenced in industry guidelines, third-party standards, and in government regulations as an important aspect of sanitary equipment construction. Yet, with such vague references as, 'adequately cleanable', 'appropriate', and 'compatible', it is common for minimally sanitary equipment to be in use despite the negative effects this process inappropriate equipment may have. National Bulk Equipment, Inc. (NBE) has taken a proactive effort to ensure that it's process-specific sanitary bulk material handling equipment provides optimal compliance contribution.
These weld seams, in the product contact area, are continuous and ground to a No. 4 finish.
Regarding materials of construction, NBE uses findings from their pre-production, HACCP assessment to guide the framework and component designs and the selection of the materials of construction. This step puts in priority the protection of personnel and product; reduces cleaning, validation, and inspection times; and enables the highest compatibility with the environmental conditions specific to the process operation. For example, as appropriate, the structural framework, located below the product contact zone can be carbon steel. However, that carbon steel will be sandblasted, fabricated with smooth-ground continuous welds, and then primed and painted with FDA-approved epoxy paint. Materials in product contact and adjacent areas, are constructed of Type 316L stainless steel, also with continuous-weld seams. These stainless steel seams are then ground to a No. 4 finish to eliminate any divots, crevices, or other imperfections in the weld seam where microbial contaminants could accumulate.
In materials of construction, as in every aspect of process-specific sanitary bulk material handling equipment design, specifications beyond the standard are what achieve OCC and the resulting process advantages of: reduced time targets for cleaning, validation, and inspection; minimal labor allocation for cleaning and validation; limiting of consumables (water, chemicals, power) during cleaning; and increased repeatability of positive inspection outcomes.
Related posts:
- Sanitary Bulk Material Handling Equipment Cleanability: Value, Risk & Outcome
- Sanitary Bulk Material Handling Equipment Accessibility: Bringing Speed, Safety, and Confidence to Cleaning
- Bulk Material Handling in Sanitary Applications: Regulatory Influences and Compliance-ready Equipment Design
- Bulk Filling and Discharging Equipment Guide Book Presents In-use Advantages of Application-specific Sanitary Equipment Versus Force-fit General Equipment
- Sanitary Bulk Material Handling Equipment: Structural Design and Contaminant Removal